Instruction Manual

DRC GATEWAY
4
1. Commission/Joining Border Router to a network
1 Installation
The DRC Gateway must be installed by a professional or certified technician conversant
with the certification requirements of the installation site.
The DRC Gateway requires a voltage between 10 VDC and 24 VDC capable of supplying up
to 2A.
Unless otherwise specified the DRC Gateway ships with a 3 dBi antenna (EA002058). The
DRC Gateway is compatible with the following antennas.
BossPac PN Gain
EH002058 (Standard) 3 dBi
EH002059 1.2 dBi
EH002060 8 dBi
EH000625 11 dBi
2 Commissioning
2.1 Set-up & Power On
- Connect one end of the Ethernet cable to your ethernet router.
- Connect the other end of the Ethernet cable to the border router (Figure 1)
Figure 1
- Connect the Power Supply corresponding wires to Border Router power port (Figure 2)