Instruction Manual

DRC GATEWAY
5
Figure 2
- Connect to the 915 MHz Antenna to Border Router (Figure 3)
Figure 3
- Power on/ Plug in the power Supply
2.2 SSH to Border Router
- On your laptop open Command prompt
- On command prompt type “ssh pi@###.###.##.##” “#” = Border Router IP address
- If connecting to the border router for the first time, command prompt will print “Are you
sure you want to continue connecting (yes/no)?”
- Type on command prompt “yes”
- If the border has a password, command prompt will ask you for a password in which then
you type password and then press enter.
- Command prompt will print “pi@###.###.##.##:~ $”