User Manual

-11-

DIRECTIONAL EXHAUST DEFLECTOR

Disconnect air supply. Rotate exhaust deflector to desired position. Reconnect air supply.

ACCESSORIES AVAILABLE

BC601 4 oz. Stanley-Bostitch Air -Tool Lubricant

BC602 1 pint Stanley-Bostitch Air -Tool Lubricant

BC603 1 pint Stanley-Bostitch “Winter-Formula” Air-Tool Lubricant

BC604 1 quart Stanley-Bostitch Air -Tool Lubricant

100679 Lube, (1lb. can)

851325 LOCTITE Grade 271 (.02 oz.)

851385 LOCTITE Grade 242 (.02 oz.)

108550 Vinyl Siding Trip 438/538

106427 Wrench, Sleeve Cap

108212 Kit, Long Magazine 400/500 S2

108213 Kit, Long Magazine 400/500 S4

108214 Kit, Long Magazine 400/500 S5

RECOMMENDED TOOLS

1 8mm Nut Driver

1 5mm Hex Wrench

1 4mm Hex Wrench

1 3mm Hex Wrench

1 2.77mm (.109”) diameter Pin Punch

1 5.56mm (.219”) diameter Pin Punch

1 Hammer

1 Small Straight Blade Screw Driver

The 400 & 500 series staplers contain a Quick Release Magazine feature. The magazine is spring

loaded to reduce jamming. When a jam does occur, a quick release mechanism at the rear of the

magazine allows the magazine to move back, in order to clear the jam.

ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A

JAMMED FASTENER.

If a jam does occur, locate the latch at the rear of the magazine (fig.1). Pull down on the latch to

open (fig.2), and rotate it clockwise 1/4 turn (fig.3). Pull back on the latch (fig.4). This will pull the

magazine back to clear the jam. After removing the jammed fastener, push on the latch, rotate it

1/4 turn counterclockwise and push up to close.

QUICK RELEASE MAGAZINE

FIG.3

FIG.2

FIG.1

FIG.4

OPEN

PULL

Exhaust

Deflector