User Manual

-11-
The DIAL-A-DEPTH
™
Fastener Control adjustment
feature provides close control of the fastener drive
depth; from flush with the work surface to shallow
or deep countersink. First, set the air pressure for
consistent drive in the specific work as described
on page 5, then use the DIAL-A-DEPTH
™
Fastener
Control adjustment to give the desired depth of
drive.
TO ADJUST DIAL-A DEPTH
TM
FASTENER
CONTROL ADJUSTMENT:
Models N52FN and N62FN, contain a Jam Release feature.
ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A
JAMMED FASTENER.
JAM RELEASE
Always disconnect air supply: 1. Before making adjustments; 2.
When servicing the tool; 3. When clearing a jam; 4. When tool is
not in use; 5. When moving to a different work area, as accidental
actuation may occur, possibly causing injury.
1
2
3
4
5
6
Partial Release Of Magazine
3: Slide magazine to rear of tool
4: Clear Jam
Jam Clearing
Disconnect air supply from tool.
Relieve fasteners from pusher.
1: Depress latch button
2: With the latch button depressed, rotate latch
assembly upward & forward until latch is on
upward position
Full Release Of Magazine
5: Pull latch upward
6: Rotate latch assembly to forward direction
Magazine Assembly Removal
7: Slide the magazine assembly to the rear of tool
to disengage
To re-assemble the magazine assembly back on
the tool
Reverse the procedures and re-engage the latch to
lock the magazine assembly in place
“DIAL-A-DEPTH
™
” FASTENER CONTROL ADJUSTMENT
TRIP ADJUSTMENT
NUT
Shallow
Deep