Installation Guide

ASSEMBLY INSTRUCTIONS
HARDWARE USED
Screw 1-3/8” L x 4
Bracket x 4
Anchor x 4
Screw 5/8” L x 4
HARDWARE USED
Plastic strap x 2
17
25. Attach brackets (10) to back panels
using screws (13). Tighten screws
using Phillips screwdriver.
Mark two desired locations on wall. Drill
two 3/16" holes on wall. Insert plastic
anchors (12) into 2 holes in wall as
shown.
Tip: You may want to hammer plastic
anchors into wall.
Attach brackets (10) to wall using
screws (9).
Tighten screws (13) using Phillips
screwdriver.
26. Move item close to the wall brackets
(10) and tie in both brackets (10) with
plastic chains strap (11) as shown in
Figure 26.
26
25
9
13
10
12
9
10
12 10
13
11
11