Installation Guide

Note: Drilled hole or plastic anchor not required when
mounting to stud, use screw only. We do not supply hardware
for mounting on concrete walls.
Figure 1
Find a desired location and mark 2
locations for screws on wall
One screw (for each unit) must be
attached directly into a wall stud. Wall
anchor is not needed when mounting to
wall stud.
Drill two of the marked 3/16" hole (for
each unit).
Insert plastic anchor (A) into the holes
on wall as shown (You will need a
hammer help you).
Using the Phillips screwdriver, install
Screws (B) into the anchors (A) and the
remaining marked holes. Turn the
Screws (B) until there is a gap of
approximately 3mm between the head
of the screw and the wall as shown.
Figure 2
Hang the Aura wall sculpture (1/2)
onto the Screws (B) and verify the wall
sculpture is resting securely on the
mounting Screw (B).
Now your Aura wall sculpture is ready to
use.
Page3
2PC Aura wall Sculpture Set
Assembly Instructions
"The hole measurements on
the wall must match with the
hole measurements on back
of the unit"