HZ349300TX Shelf- Black HZ349400TX Shelf- White For assistance with assembly contact: Southern Enterprises Inc. Customer Service 1-800-633-5096 Assembly Instructions service@seidal.com www.seidal.
Shelf Parts List Please check packaging for all parts and hardware before discarding. Unpack and lay parts on clean, padded surface like carpet or blanket. Check that you have all parts indicated. Call customer service if hardware is missing. Before beginning assembly, carefully study the diagrams below and sort your hardware according to the pictures. Using the incorrect hardware will cause damage.
Shelf Assembly Instructions Connect shelves (I) and shelves (H) to back board (G) with screws (B). Tighten screws with phillips screwdriver. Figure 1 Cover screw holes with sticker covers (C) as shown in figure 2.
NOTE: NO DRILLED HOLE OR PLASTIC ANCHOR Find a desired location and mark two REQUIRED WHEN MOUNTING TO WOOD WALL.USE SCREW ONLY. WE DO NOT SUPPLY HARDWARE FOR MOUNTING ON CONCRETE WALLS locations for the screws. One screw (for each unit) must be attached directly into a wall stud. Wall anchor is not needed when mounting "The hole measurements on wall must match with the hole measurements on back of the unit" to wall stud. Drill one marking 3/16" hole (for each unit).
Parts Replacement Form Customer Information Name Address City/State/Zip Code Phone Number Please indicate where you purchased this item: Store/Website/Catalog Please indicate color/size/style number: Style No Needed Parts Letter Parts Description Quantity Please immediately examine this product carefully. Any request for missing parts or damage replacement must be received within 90 days of your receipt of the product. Replacement, if available, will be honored within this time frame.
CAUTION Max shelf load capacity is achieved by mounting screw into studs or cement walls. If mounting to sheet rock (cavity wall) it is advisable to mount at least one screw (without anchor) directly to a wall stud or studs. However do not leave either end of mounting bracket unsupported by at least one anchor. For hollow wall mounting you can use any of the holes in the back plate to suit where you require the mounting screws positioned.