User Guide

Patient Trial Handbook

Remote Control Battery Replacement

1. On the rear of the remote, push in slightly and

slide down the battery compartment cover.

2. Remove the old batteries.

3. Place the three new AAA batteries in the slots,

matching the positive (+) and negative (-)

markings.

4. Align the cover on the case and slide the cover

into position until it snaps closed.

The Remote Control will connect to your Trial Stimulator in approximately 30 seconds.

Trial Stimulator Battery Replacement

It’s not likely to happen over the short term of your SCS trial period, but your Trial

Stimulator battery may drain to a very low level. If this happens, install a new battery right

away.