User Guide

Patient Trial Handbook 54 “No Response” on the Display When the Remote Control displays “No Response,” there is a communication problem between the remote and the stimulator probably caused by a weak battery. Press the Dbutton. If the Remote Control is still not able to communicate with your stimulator, the “No Response” message will appear again; press D again. If the remote connects with the stimulator, you will be returned to the display you were using before the problem began. If the problem cannot be corrected, the Remote Control will go into sleep mode. Replace the Trial Stimulator battery, reactivate the Remote Control (see page 30), and try the action again. Occasionally, telemetry problems happen because the Remote Control cannot find the stimulator because of orientation or interference. Move the remote closer and then press the Dbutton. Call our Customer Service Department at [phone] if the problem continues.