System Handbook

Patient System Handbook
32
Stimulation On and Off
The Remote Control uses a “dedicated” stimulation
on/off switch. You may press at any time—even
during the Remote Control’s sleep or idle mode—to
turn stimulation on or off. The Remote Control will
briefly display a message notifying you of the on or
off status.
Signal Strength
The Remote Control indicates the signal strength
between the unit and the Stimulator in the upper right
corner of the display:
• If there are no signal bars, move the Remote Control
closer and tilt it. If there are no signal bars, communication may still be achieved,
however, it is at a very weak level.
• If there are 1 or 2 signal bars, there is adequate communication between the Remote
Control and the Stimulator.