User Manual

Patient Remote Control

programmable parameters, which are combined into a

program to achieve optimal pain coverage.)

Separately controlled areas within the same program cannot

share the same electrodes when the stimulation is monopolar,

utilizing the IPG or external patch electrode as the anode.

Electrode Configuration

1. Electrodes are numbered 1-16 (8 per side), and displayed as

shown in the figure below. Use the T (down) and S(up) buttons

to cycle E1 through E16.

2. When the desired electrode number is reached, configure the

polarity (+/ -/0) by pressing the

SEL 1 button until the intended

polarity is shown on the respective electrode.

Note: When changing a configuration, the amplitude of the edited

area will be reduced to 0.0 and stimulation to all other areas

will be turned off.

3. If you have changed a configuration, gradually increase the

amplitude of the edited area to a comfortable level.

4. To restore stimulation at previous levels to all other areas, briefly

press the power button once, then press it a second time.