Handbook

Patient Trial Handbook
26
Help
Stimulation
No Stimulation
1. When stimulating, the Trial Stimulator status light will blink. If it is not blinking, toggle the
power button on the Trial Stimulator or the Remote Control. When the Remote Control receives
confirmation from the Trial Stimulator, it will flash “Stimulation On.”
2. When the status light is blinking and you still do not feel stimulation:
a. Check to make sure the lead cable is properly connected to the stimulator. Turn the stim-
ulator “off” before adjusting the cables, and then turn it back “on.”
b. If you were provided a skin patch electrode, check that it is properly secured to your
skin. Make sure to turn the stimulation off first, and then back on.
c. Try turning up the level of the stimulation. If this does not bring on stimulation, turn it
back down.
3. When the status light will not blink and you do not feel stimulation, replace the Trial Stimulator
battery.
4. Call your physician’s office if the above steps do not solve the problem.