User's Manual

Table Of Contents
2. Rotate the wrench clockwise (for retracted setscrew) or counterclockwise (for extended setscrew) around
the axis three times, such that the handle of the wrench orbits the centerline of the screw (Figure 7 on
page 66). The torque wrench handle should not turn or twist during this rotation.
3. As needed, you may attempt this up to four times with slightly more angle each time. If you cannot fully
loosen the setscrew, use the #2 torque wrench from Wrench Kit Model 6501.
4. Once the s etscrew has been freed, it may be extended or retracted as appropriate.
5. Discard the torque wrench upon completion of this procedure.
65