Operating instructions

System Connections

• Please be certain that this unit is unplugged from the AC outlet before making any connections.

• Be sure to observe the color coding when connecting the preamplifier and speakers to this unit.

• Make connections firmly and correctly. Poor connections can cause loss of sound, noise or damage to the unit.

• For connections between this unit and the Boston Acoustics compatible preamplifier such as AVP7, refer to the AVP7's

manual.

Notes:

• Do not place other equipment on top of this unit so that the radiated heat can be properly dispersed.

• When installing in racks, etc., leave more than

12" (30cm) of space at the top.

1. DC TRIGGER IN

If this unit is connected to Boston Acoustics AVP7, connect

this jack to the “1” jack of DC TRIGGER OUTs of the AVP7

directly for system power control.

(For details, refer to the operating instructions of AVP7)

Note:

When making DC TRIGGER connection, you should use

the stereo mini cord supplied with this unit, not a mono mini

cord.

2. GROUND TERMINAL

If necessary, connect this terminal to the “GND” of other

component.

3. AC INLET

Plug the supplied AC input cord into this AC INLET and then

into the wall AC outlet.

Note:

Do not use an AC input cord other than the one

supplied with this unit. The AC input cord supplied is designed

for use with this unit and should not be used with any other

device.

To a wall AC outlet.

Sherwood pre amplifier P-965

DC TRIGGER OUT