Owner`s manual
5-2
The following indications, connections and controls are present on
the rear panel:
Rear Panel of the 1021
Serial Number. 1.
The serial number of the unit is engraved on
the right-hand side of the rear panel. Write the serial number
here for your records: ___________.
AC Mains Power Connection. 2.
The 1021 AC mains power
connection is a grounded (three-prong) 15A IEC connector. It is
not recommended that the ground be lifted on the 1021.
Master AC Switch. 3.
This switch powers the 1021 ON or OFF.
Fuses. 4.
There are two fuse sockets on the rear panel to protect
the player from excessive current draw. Note: Never replace a
fuse with the incorrect rating or size.
Digital Output Connection. 5.
The 1021 features an AES3 digital
output connector to feed a digital server, recorder or separate
processor. The digital connection will output the native data
rate of the track being played.
IR Input Connections. 6.
The 1021 features an external IR input
if the front panel Infrared Remote Receiver is obstructed. The
1021 is also fully compatible with external control software such
as Crestron or AMX via the IR connection. Please contact your
dealer for further information regarding this connection.
Boulder Link Control and Connections. 7.
The 1021 can be
connected to other Boulder products for remote turn-on and
status indications. For further information regarding Boulder Link,
please see page 13-6.
12V Trigger Connections. 8.
The 12V trigger connection will
allow you to turn on an amplier with an equivalent connection
by simply turning on the 1021. The amplier will also turn off
when the 1021 is placed in Standby Mode. Please contact your
dealer for further information regarding this connection.
Analog Output Connections. 9.
These are the main outputs
of the 1021. There are two connectors per channel and each
1021 Rear
Panel