Owner`s manual
8-4
Note: the volume control MUST be set to Variable mode or possible
system damage may occur!
Connect the Left channel interconnect cable (usually white) to
one of the Left channel output connectors of the 1021. As both
connectors are the same, it does not matter which left channel
connector is used. The other end of the cable should be connected
to the left channel amplier input.
Connect the Right channel interconnect cable (usually red) to
one of the Right channel output connectors of the 1021. As both
connectors are the same, it does not matter which right channel
connector is used. The other end of the cable should be connected
to the right channel amplier input.
Connecting a Second Set of Outputs
The 1021 is outtted with two pairs of output connectors to drive sec-
ondary ampliers, recorders, or subwoofers. Both pairs of outputs will
operate in tandem and cannot be controlled independently, whether
the volume control is in Fixed or Variable mode.
Connect the Left channel interconnect cable (usually white) to the
remaining Left channel output connector of the 1021. The other end
of the cable should be connected to the left channel input of the
component you are connecting.
Connect the Right channel interconnect cable (usually red) to the
remaining Right channel output connector of the 1021. The other
end of the cable should be connected to the right channel input of
the component you are connecting.
Connecting the 1021 with Unbalanced Connections
It is strongly recommended that the 1021 be connected with
balanced connections wherever possible in order to enjoy the
true performance for which it was designed. If it is not possible to
use balanced connections, it is still possible to connect the 1021.
There are two methods of connecting the 1021 with unbalanced
connections:
Connecting the 1021 to Your System
Connecting
The 1021