Owner`s manual
12-22
The Boulder Link ID can be set for values of 16 through 31. To
select an ID number, use the Navigate Left or Navigate Right
button to select the specic ID number you prefer.
For further information regarding Boulder Link, please see
page 13-2.
Boulder Link Control
The Boulder Link Control submenu displays the position of
the Master/Slave switch on the rear panel. No settings can
be changed from this submenu. The switch position must be
changed on the rear panel.
For further information regarding Boulder Link, please see
page 13-2.
Remote Control ID
The Remote Control ID submenu determines the ID setting of
the remote control system.
The Remote Control ID can be set to 0, 1, 2, 3, 4, 5 or 6. The
factory default remote control ID number for the 1021 is set to
5 at the factory and/or when a Factory Reset is performed.
To select an ID number, use the Navigate Left or Navigate
Right button to select a specic Remote Control ID number.
This feature is used in conjunction with a wiring change in
the remote control and should always be set at 5 unless the
1021 remote control system interferes with the operation of
other electronics in your home. Consult your dealer before
changing this setting.
Baud Rate
The Baud Rate setting increases Boulder Link’s compatibility
with other brands of remote control equipment.
Setup and Programming
Setup &
Programing