Owner`s manual

29843-2-0612 Page 31
Finishing The Wall for DF412BL Decorative Front With Inside Fit
The inside t front allows for nishing over the face of the replace and right up to the removable front.
1. After installing the replace, install the front kit.
2. Locate the side stone stops, loosen the four front screws a few turns - do not remove them.
3. Slip the side stone stop under the four screws and tighten. Repeat for the other side.
4. Locate the steel hood stone stop. Loosen the 7 screws under the top edge of the replace - do not remove. Slip the hood stone
stop under the 7 screws and tighten while holding back tightly to the top face of the replace.
5. Secure front face of the hood stone stop to upper replace face with three screws.
6. Hang the front on the four rectangle cut-outs on the face of the replace.
7. Finish around the replace, you must use only non-combustible material to cover the steel face and non-comb board on the re-
place. All non-combustible nishing materials must stop at the side and hood stone stops. Finishing material must not go past the
stone stops of the front will not t. Stop the nishing material at the bottom of the valve opening so the valve and fans are clear for
service.
FINISHING THE WALL
►
►
▼
◄
55-1/2” x 13-1/2”
(141cm x 343mm)
NON-COMBUSTIBLE BOARD
HOOD
STONE STOPS
SIDE
STONE STOPS
SIDE
STONE STOPS
NON COMBUSTIBLE
BOARD
2” x 24” (5cm x 61cm)
NON COMBUSTIBLE
BOARD
2” x 24” (5cm x 61cm)
Figure 47
◄
◄
STOP THE FINISHING
MATERIAL ON TOPOF
THE HOOD STONE STOPS
STOP THE FINISHING
MATERIAL ON TOPOF
THE SIDE STONE STOPS
STOP THE FINISHING MATERIAL FLUSH
WITH THE BOTTOM OF THE VALVE OPENING
NON COMBUSTIBLE
BOARD
NON COMBUSTIBLE
BOARD
Figure 48