Owner`s manual
29843-2-0612 Page 33
DVLL GLASS MEDIA INSTALLATION
Installation of the glass media is critical to safe and clean op-
eration of the replace.
WARNING
Failure to position the parts in accordance with the dia-
grams and instructions below or failure to use only parts
specically approved for use with this heater may result in
property damage or personal injury.
DECORATIVE GLASS ACCESSORY PLACEMENT
This Linear Contemporary replace is approved for use with
smooth glass media measuring as small as 1/4 inch and up to 1/2
inch in diameter. Empire Comfort Systems offers a selection of
glass media for this replace. Additional colors may be available
from your Empire dealer. Use properly sized smooth glass media
approved for gas replaces. Follow the diagrams in this manual for
placement of media and clearance to burner ports.
CAUTION
Use of gloves and eye protection is required while applying
the decorative glass.
▲
▼
▲
BURNER
GLASS MEDIA RETAINER
MEDIA TRAY
▲
GLASS MUST NOT BE PLACED ON TOP OF OR
NEXT TO BURNER. GLASS TO BE PLACED ONLY
TO THE OUTSIDE OF THE FLANGED OPENING.
Figure 52
1. Remove the front and the glass frame assembly.
2. Place the long thin glass piece (glass media retainer) into the
groove in front of the media tray in the firebox opening. This
will keep the glass beads from falling out.
3. Place dime-sized pieces of ember across the burner surface.
A single layer, is sufficient; do not over-apply.
4. Carefully open the 7.5 lbs. bag of glass beads. Distribute the
glass beads evenly across the media tray, taking care not to
let the glass beads fall down by the burner or the pilot. If they
do, make sure they don't block the burner or pilot. There are
1/2" walls around the burner, pilot and back air slots to keep
the beads out.
5. Replace the glass frame assembly and decorative front.