Owner`s manual

29843-2-0612Page 40
OPTIONAL DECORATIVE GLASS PANELS (DVLL ONLY)
NOTE: INSTALL GLASS PANELS BEFORE INSTALLING THE
GLASS MEDIA BEADS.
PLACING THE OPTIONAL DECORATIVE GLASS PANELS
INTO THE DVLL41 FIREPLACE:
1. Remove front glass and door. Be sure there are no glass
media beads on the media tray.
2. Carefully unpack the glass pieces. Wear gloves to prevent
any accidental cuts and to prevent ngerprints on the glass.
3. Slide the large narrow glass pieces down through the small
tabs and into the slots in the media tray base in back outside
areas.
4. Slide the large glass panels down through the small tabs and
into the slots in the media tray base in the back center area.
5. Slide three small glass pieces down through the small tabs
and into the slots in the media tray base in front.
6. Install the glass media beads around the media tray to hide
the small tabs that hold the glass (see DVLL Glass Medial
Installation Section). The glass edges will be illuminated from
the light below the media tray.
Figure 57
LARGE GLASS
PANELS
LARGE GLASS PANELS
SMALL GLASS PANELS