Owner`s manual

29843-2-0612Page 46
CAUTION: ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE WITH ALL LOCAL,
CITY AND STATE BUILDING CODES. BEFORE MAKING THE ELECTRICAL CONNECTION, MAKE SURE THAT MAIN POWER SUP-
PLY IS DISCONNECTED. THE APPLIANCE, WHEN INSTALLED, MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE WITH
LOCAL CODES OR, IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL ELECTRICAL CODE ANSI/NFPA 70 (LATEST
EDITION).
A factory installed junction box is located on the lower right side of
the replace. Wiring must be fed to the junction box and attached
to the receptacle that is provided. Leave approximately 6" of wire
in the junction box for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached
to the green (ground) screw.
Install the receptacle into the junction box. Attach cover plate.
▲
►
▼
◄
◄
JUNCTION BOX CONNECTIONS
JUNCTION BOX
BLACK
GROUNDWHITE
110 VOLT
POWER SUPPLY
JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS
Figure 58
ACCENT LAMP LIGHT REPLACEMENT - DVLL
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1. Unplug the remote from the junction box or disconnect all
power to the replace.
2. Remove the decorative front access panel.
3. Remove the valve cover to access the area underneath the
rebox.
4. Remove the wing nuts on each side of the light socket. Lower
the socket straight down.
5. Wearing gloves, pull the light bulb out of the socket.
Replace the light bulb with a new one of the exact type,
making sure the white gasket is in place around the bulb.
IMPORTANT: Do not handle the lamp (bulb) with bare
ngers, protect with clean dry cloth.
6. Raise the socket and bulb straight up onto the bolts and tighten
the wing nuts. DO NOT OVER-TIGHTEN.
Your Luxury Direct Vent Gas Fireplace (DVLL ONLY) comes equipped with our
"Accent Lamp." The light has been pre-wired and is controlled from the remote.
Figure 59
NOTE: The lamp will pull straight out of the socket.
Replace with 35 Watt/120 Volt Halogen bulb.
When re-installing, ensure integrity of gasket seal.
Light bulb specs if purchased at a hardware store:
· 120V, 35W
· Halogen, GY6.35
· Base, T3 Shape
Replacement Parts Number:
· Bulb R10928
· Red colored light lter R10924
▼
◄
◄
▼
WING NUTS
UNIT SHOWN FROM THE BOTTOM WITH THE BASE REMOVED FOR CLARITY.