Owner`s manual

29843-5-1012Page 12
INSTALLATION
Framing and Finishing
NOTE: You must use the standoffs that are supplied with the
replace. The standoffs are shipped in a at-state on top
of the replace.
1. Locatethetwo(2)steelstandoffsandtwo(2)headershields
attachedtothebackofthereplace.
2. Removethetwo(2)screwsthatsecurethestandoffsandheader
shieldsinplace;savethescrews.
3. Therightandleftstandoffshaveaperforationlocatedinthe
middle.Bendthemattheperforationtoalittlemorethan90°.
4. Bendtheshorttabsoneachendtheoppositedirection.Secure
thestandoffstothereplacetopwiththree(3)screwseach
fromthehardwarebag.Therearepilotholeslocatedinthe
topofthereplaceforeachstand-off.
5. Verifythatthefrontofthestandoffsare1/2in.(13mm)back
from the face of the replace.  Verify that the stand-off is
12in.(305mm)tall.
6. Locatethebottomheadershield;itistheshorterone.Using
four(4)screws,attachitbetweenthestandoffs.
7. Locatethetopheadershield;itisthelongerone.Usingfour
(4)screws,attachitbetweenthestandoffs.See Figure 12.
8. Removethenon-combustibleboardthatisshippedbetween
thereplaceandpallet.
9. Frameinreplacewithaheaderacrossthetop.
IMPORTANT:Allowfornishedfacewhensettingthedepth
oftheframe.
10. Attachthereplacetotheframing.See Figure 12.
11. Installthenon-combustibleboardacrossthetopandsidesof
thereplace.Theboardsitsonthe1/2in.surfaceontopofthe
replaceandinfrontofthestandoffs.See Figure 11.
IMPORTANT: IN ORDER TO USE SOME OPTIONAL FRONTS
YOU MUST RAISE THE FIREPLACE ON A HEARTH SO THE
BOTTOM OF THE FIREPLACE IS A MINIMUM DISTANCE
ABOVE THE TOP OF THE HEARTH EXTENSION FINISHING
MATERIAL. CHECK DECORATIVE FRONT DIMENSIONS
PRIOR TO SETTING THE HEIGHT OF THE FIREPLACE
HEARTH EXTENSION.
NON-COMBUSTIBLE
BOARD
Figure 11
Flush Mount Mantel Installation
The fireplace must extend 3/4 in. (19mm) beyond finished
wall surface when using a ush mount mantel. Refer to Figure
12 to locate nailing anges on replace sides. Mark and drill
four (4) 1/8 in. holes into replace side to mount each nailing
flange. Use eight (8) 1/2 in. hex-head screws supplied in
hardware package to attach nailing anges to replace sides.
◄
▼
▼
STAND-OFF
STAND-OFF
TOP
HEADER SHIELD
BOTTOM
HEADER SHIELD
NAIL OR OTHER SUITABLE
FASTENER
▼
Figure 12