Operating Manual

Operating Manual - Recce 360 mini (V2.0 20220524)
The Recce 360 mini has two mounts on opposite sides. There is no preferred mount. The two
mounts can be used at the same time to attach other accessories.
To attach an accessory, screw it down into the mount. There is protection in the back to prevent
it from being inserted too far.
When using accessories, note that it connects to the camera below the protective rubber. This
means that the camera is not protected from shocks and drops exerted on the accessory.
An accessory as a heatsink (Recce 360 mini)
The mount is integrated into the camera heatsink. That means certain accessories can also be
used as an external heat sink to cool down the camera. This might be used when running the
camera for a long time or in hot environments.
The bottom side of the camera (speaker side, bottom view - C) will benefit most in this case and
hence is the preferred side to connect to.
4. Storage
The storage environment should be non-condensing and be between 10C and 30C (50F - 86F).
The camera is best stored with an approximately half-charged battery. When storing for longer
periods the charge level should be checked every 3 months, and if needed be charged.
5. Maintenance
5.1 Cleaning
The outside of the camera can be cleaned with a dampened (not wet) microfiber cloth. Make
sure not to use any abrasive or aggressive cleaning products.
5.2 Servicing
The camera does not contain any parts that can be serviced in the field.
After (partial) disassembly, for a proper panoramic image, a custom calibration is required. This
can only be done using special equipment that is only available at the factory.