Operating Manual

Operating Manual - Recce 360 mini (V2.0 20220524)
3. Operating instructions
3.1 Unpacking
The Recce 360 mini comes in an IP65-protected container. After the container is opened, the
camera can be taken out of the container without further precautions.
Before powering up, it is recommended to charge the camera (see section 3.2).
3.2 Charging
To charge the camera plug in the USB connector of the supplied charger in the charging socket
(controls view - D). When the camera is charging, an indicator LED (controls view - C) will be lit.
The Recce 360 mini has a green charging indicator.
When the camera has finished charging the batteries the indicator will be turned off. When there
is an error charging the batteries, the indicator will flash.
3.3 Power up
To power up the camera, press the power symbol on top of the camera (top view - A). There
should be tactile feedback from the switch below the rubber (controls view - B) when pressed.
Keep pressing until the haptic feedback from the integrated vibration motor is felt. The motor will
vibrate once.
The camera is now powered up. After power-up, it takes on average between 10 and 20
seconds before the camera has booted up and is ready to use.
3.3.1 Checking power state
The camera power state can also be checked without shutting it down or powering it up. When
opening the protection flap (top view - A), short-press the button (controls view - B). If the led
indicator lights (controls view - C) are flashing, the camera is powered up.
3.4 Operating
After the camera is powered up and booted it is ready to stream video and audio to a mobile
device. Please refer to the “app manual” for instructions on how to use the app and do initial
setup on the mobile device.