Installation guide

Quadro2x Manual II: Administrator's Guide Appendix: System Default Values
Quadro2x, Quadro2xi; SW Version 3.1.x 93
Parameter System Default Value
Server – undefined.
Extension Settings – Remote Remote Extension – disabled
Extension Settings – Call Queue Call Queue – disabled
Extension Settings – Voice Mailbox
Extension 11 – Internal Voice Mail,
Extension 12 – Disabled Voice Mail.
Extension Settings – Codecs
Codecs - G711u (preferred), G711a, G729a, G726/32, G726/16, G726/24, G726/40
Out of Band DTMF Transport – enabled,
T.38 FAX – enabled,
Pass Through FAX – enabled,
Pass Through Modem – disabled,
Force Self Codecs Preference for Inbound Calls - disabled.
Attendant 00 Settings – General
Display name – Attendant, FAX forwarding – disabled,
Percentage of System Memory – 3%.
Attendant 00 Settings – Attendant
Scenario
Scenario – default,
Send AA digits to Routing Table – disabled,
Welcome and Menu messages – default,
Authorized Phones Database – undefined.
Attendant 00 Settings – SIP and SIP
Advanced
Same as for an extension.
Attendant 00 Settings - Codecs
Codecs - G711u (preferred), G711a, G726/16, G726/24, G726/32, G726/40, G729a,
G723, iLBC
Out of Band DTMF Transport – enabled,
T.38 FAX – enabled,
Pass Through FAX – enabled,
Pass Through Modem – disabled,
Force Self Codecs Preference for Inbound Calls - disabled.
Receptionist Management No entries
Call Statistics
Enabled
100 entries for all type of calls
SIP Settings
UDP and TCP Port – 5060,
Session Timer – disabled,
DNS Server for SIP – default,
SIP timers – RFC 3261.
RTP Settings
Properties for all Codecs except G723 and iLBC :
Packetization -20ms
Silence Suppression -yes
G723 and iLBC properties:
Packetization - 30ms
Silence Suppression – yes
RTP/RTCP port range for FXS lines - 6000-6049
RTP/RTCP port range for IP lines - 6050-6099
G276 Standard - ITU-T specification
Telephone Event Draft Support - enabled
RTCP Support - disabled
NAT Traversal Settings
NAT Traversal for SIP – force
SIP and RTP Parameters - Use STUN
SIP TCP Port – 5060
STUN Parameters:
Primary STUN Server - stun.epygi.com
Primary STUN Port – 3478
Secondary STUN Server – undefined
Secondary STUN Port - undefined
Polling Interval: 1 hour
Keep-alive interval: 120 seconds
NAT IP checking interval: 300 seconds
No entries in NAT Exclusion table
Line Settings
Onboard Lines Configuration:
CallerID- Standard 2 FSK for all lines
Ringer type: Type A for all lines
Busy Tone and Power Disconnect indications: disabled for all lines