User`s guide

Installation 22
User Settings
Use the chart below to document your system and terminal settings:
Parameters
Examples:
Your Settings:
Number of sessions
2
Host/Printer (Session 1)*
EINPara
Host/Printer (Session 1)*
AuxlNone
Emulations (Session 1)
ADDS-VP
Emulations (Session 2)
VT-300-8
Host 1:
Baud
Data Bits
Stop Bits
Parity
Parity Check
Flow Control (In)**
Flow Control (Out)***
Modem Control
9600
8
1
None
Off
Xon-Xoff
Xon-Xoff
On
Dual Host mode only, press
CTRL-Enter (kpd):
Host 2:
Baud
Data Bits
Stop Bits
Parity
Parity Check
Flow Control (In)**
Flow Control (Out)***
Modem Control
19200
7
2
Odd
On
DTR(prDSR)
QJR (or DSR)
Off
Notes: * In most cases, these parameters should not be the same.
Incoming flow control on the host should correspond to "EIA (or Aux) Rcv."
Outgoing flow control on the host should correspond to "EIA (or Aux] Xmt."