Product Manual

4
EASY ASSEMBLY
searchcoil
searchcoil
Cable
Upper
Stem
Control
Housing
Plug
Lower
Stem
Assembling your Tracker IV Metal
Detector is easy and requires no
tools. Just follow these steps:
●
1 Using the supplied bolt and
knurled knob, attach the
searchcoil to the lower stem.
●
2 Press the button on the upper
end of the lower stem and slide
the lower stem into the upper
stem.
Adjust the stem to a length that lets you
maintain a comfortable upright posture,
with your arm relaxed at your side.
●
3 Wind the searchcoil cable around
the stem. Leave enough slack in
the cable to let you adjust the coil
when you are hunting on uneven
ground. Then tighten the knob at
the end of the searchcoil.
Note: To adjust the coil,
simply loosen the knob.
●
4 Insert the coil’s plug into the
matching connector on the control
housing. Be sure the holes and
pins line up correctly
.
Caution:
• Do not force the plug in.
Excess force will cause damage.
• To disconnect the cable, pull out
the plug. Do not pull on the cable.
Lower
Stem
Upper
Stem
Connector
on back of
control housing
Bolt
Knurled
Knob
Bottom view
Bottom side