Product Manual

Quick Start DEMONSTRATION

Here is a quick way to demonstrate the basic features of your Tracker IV.

I. Supplies Needed

• A quarter (25¢)

• A nickel (5¢)

• A Penny (1¢)

• A small piece of aluminum foil

• A Nail

II. Position your Tracker IV

• Place the detector on a table, with the searchcoil hanging over the edge.

• Be sure that the searchcoil is far away from walls or metal objects. Keep the searchcoil away

from any metal in the table.

III. Beginning Switch Settings

• Right Knob (Discriminate) – LOW

• Toggle Switch – Middle Position

• Turn detector on with "Sensitivity"

knob set to 3:00 position

• Reduce "Sensitivity" in case of interference

IV. All Metal Detection

Wave all objects over the searchcoil

• NOTICE THE SINGLE TONE

V. Tone Mode Detection

A. Move toggle switch to the right position – TONE

B. Turn the "Discriminate" knob to 2:00 (about 3/4 turn)

C. Sweep all of the different objects back and forth under the

searchcoil

• NOTICE THE DIFFERENT TONES

• NOTICE THE METALS REJECTED

VI. Disc Mode Detection

A. Move the toggle switch to the left position – DISC

B. Turn the "Discriminate" knob to LOW

C. Sweep all of the different objects back and forth under the

searchcoil.

• NOTICE THE METALS REJECTED

D. Turn the "Discriminate" knob slowly to the right while

sweeping all of the different objects at different settings.

• NOTICE THE DIFFERENT TONES

• NOTICE THE METALS REJECTED

TOGGLE SWITCH

ALL METAL

TONE

FULL DISC