Wi-Fi 6 MESH AP Quick Start Guide AX6600
Overview Thank you for choosing our product. Please read this manual before use. If you need to change Internet Access method,i.e.from router to bridge mode,or add a new Mesh AP to your Mesh network,or need other information,please scan the QR code below or visit https://azoresnetworks.com/pages/download-center in the browser to view the corresponding electronic user manual for instructions.
01 Product Hardware Description Product Backside Description 批注[A1]: 需要替换 AX6600 两口的图片 Button Description Button Function WPS Set the WPS process. Short press (1 second) for reset the router; Reset Long press (5 seconds or longer) for reset to factory default settings. ON/OFF Power on and off the router.
02 Steady Green Function normally and can access the Internet Blinking Blue WPS or Mesh pairing in progress Steady Blue Pairing successful Product Manual Single Router For single router： Connect the provided network cable from the AX6600 Router to your home Broadband Gateway (i.e. cable/DSL modem, PON gateway). Please refer to SINGLE ROUTER SETUP STEPS for network setup.
批注[A2]: 图片设备体上和扫码提示文字 Master 与 Slave 需 要替换为 Main 和 Satellite For mesh router set: Main AP has the QR code on the backside,is used as the main router, which is to be connected, via provided network cable, to your home Broadband Gateway (i.e. cable/DSL modem, PON gateway); Satellite AP is used for Wi-Fi network expansion. Please refer to ONE ROUTER SETUP STEPS (for Main AP) & MESH SETUP STEPS (for Satellite AP) for network setup.
批注[A3]: 需要替换 AX6600 两口图片 The Azores Router can be connected according to the diagram above. Note the DSL/PON/Cable Gateway must be connected to the WAN port of Azores Router. When it is connected to the Internet ,the LED light is steady green. If you can, try place the Azores Router in an open area like on a table or a shelf.
AX6600 05 Azores Router APP 01 Connect your Mobile device to Wi-Fi network according to the Wi-Fi SSID and password sticker on the backside of Azores Router. 02 Download mobile APP software by scanning the QR code below or visiting https://azoresnetworks.com/pages/app-download in the browser. Scan QR code to download Azores Router APP 03 Follow the APP guidance to log in. 04 Enter the “My Wi-Fi” menu to modify WiFi configuration or perform other operations.
06 Frequently Asked Questions (3) Make sure the broadband service is normal and you have paid Internet bill. Q1 I replaced my old router with Azores (4) When all above are normal, try reboot the device Router.After connecting network cable from and then check the network once it powers back on. DSL/PON/Cable gateway to the Azores Router, the LED is keep flashing red.
network operation method. Q8 How to access the Satellite AP web management page(GUI) if the mesh pairing failed? Answer:Manually set the PC IP address to 192.168.0.X(e.g.192.168.0.100),the subnet mask is 255.255.255.0.Open the browser and enter http://192.168.0.254.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
