Quick Start Guide

6

The Azores Router can be connected according to the diagram above. Note the DSL/PON/Cable Gateway
must be connected to the WAN port of Azores Router. When it is connected to the Internet
,
the LED light is
steady green. If you can, try place the Azores Router in an open area like on a table or a shelf.

Wired devices can be connected directly to LAN port for Internet access; wireless devices can use the
network name (SSID) & password (see the sticker on the backside of Azores Router) to connect to Internet.
04 MESH SETUP STEPS
Place the Satellite AP at a proper location based on your home layout. After powering on again, Satellite AP is all
set when the LED is steady green. To optimize wireless performance, place the Satellite AP in a location that
minimizes the barrier (such as wall, door, and floor) between the Main AP and Satellite AP. We recommend one
wall/door/floor between the Main AP and Satellite AP. You can connect the Satellite AP to your Main AP via
network cable (preferred method) or wirelessly.
*Note:If you know there is a spot in your home, where the Wi-Fi signal is the weakest. Try place the Satellite AP
midway between the Main AP and the weakest spot.
*Note:When Main AP and Satellite AP pairing successfully, the SSID and Password would be same, that is
showing on the backside of Main AP.
需要替换 AX6600 两口图片批注[A3]:
图片设备体上 Master 与 Slave 需要替换为 Main
和 Satellite
批注[A4]: