User Manual

13
XMS user guide
Operation
Operation
Bowens.co.uk
Sync Source Setting continued.
2.  
until only the CELL Indicator is illuminated. The unit will be triggered
    
    
received in a pre-set time frame (see page 15). This allows the unit to ignore
    
3. To select the radio, press and hold down the SYNC button until only
the RADIO Indicator is illuminated. The unit will be triggered from an
XMSR generated trigger signal.
4. To select the radio and the photocell together, press and hold down the
SYNC button until both RADIO and CELL indicators are illuminated.
5.  
down the SYNC button until the RADIO Indicator is illuminated and
    
6.  
    
7.  
Wired Sync
1. Regardless of the sync source setting, wired sync is always available.
2. To use the wired sync source connect a 3.5mm jack sync cable to the
rear mounted jack socket, and the PC connector to the camera (or other
sync source e.g. light meter).
3. The sync cable can be extended as required using an appropriate extension.
4. Remove the jack plug when not required.

1.   
2. STDBY will be illuminated, highlighting that the unit is connected to mains power but
is in standby mode.
3. All settings will be retained when the unit is switched to standby.
4. Remove the power cable.
5. Allow the unit to cool before packing away.


is on, the settings will be retained. If invalid settings are found when the unit is next turned
on then default settings will be used.