classic GM250C Owner’s Handbook GM500C
contents warranty Information Warranty CE Mark Safety Notes Legal Notice Gemini Classic Specifications 2 2 3 11 11 Operation Controls Mounting your Gemini Classic Flash Power Control Modelling control Ready Indications Changing the Modelling Lamp Changing the Fuse Changing the Flash Tube Synchronisation Mounting Reflectors 4 5 5 5 6 6 6 6 7 11 All Bowens electrical products are covered by a two year warranty against any faulty design, materials and workmanship.
introduction Accurate, ergonomic and robust, the Gemini Classic has been designed by working closely with photographers to develop a compact flash unit that meets the exacting high standards demanded in professional studios today at the same time remaining simple and intuitive to use. All ‘S-Type’ accessories from the Bowens range can be used with the Gemini Classic as well as the Bowens Travelpak battery system and Bowens/PocketWizard radio trigger cards.
Carry Handle. gemini classic controls Modelling Lamp Mode. Modelling Lamp Level. Ready Beep On/Off. Operating your Gemini Classic. Slave Cell On/Off. The Bowens Gemini Classic can be operated from either an AC (mains) supply or from a Bowens Travelpak battery. Radio Trigger Card Slot. AC/DC Power Switch. For AC operation, the AC switch (page 4) should be in the upper position. For battery operation, the switch should be in the lower position. AC Power Input.
operation The mount bushing on the L-bracket allows for two possible ways of mounting to the stand/support (below). Method B may be found useful if the light is required to point down. A B Modelling Lamp Controls. The flash power control output level is variable over 5-stops, from full to 1/32 power. The maximum power available depends on the model (See specification table - page 11) and is denoted by the numbers 1-6 on the side control panel. The numeric divisions indicate full-f/stops.
operation Ready Indications. Changing the Modelling Lamp. Changing the Flash Tube. Test Button. Switch off the Gemini and disconnect from the power supply. Allow the lamp to cool before removing. Unscrew the modelling lamp from the lampholder in the centre of the reflector and replace with a new lamp. Ensure that the unit is switched off and disconnected from the AC supply and then wait thirty minutes before touching or removing the flash tube.
gemini classic accessories Sync Socket: The standard 1/4” socket on the rear control panel of the unit may be used for direct connection to a camera set to ‘X’ synchronisation. Two Gemini units may be connected together using a ‘Y’ connector. An infrared receiver or flash slave may also be plugged into this socket. The socket operates at +5V and is safe for use on digital cameras.
gemini classic accessories Travelpak Battery System. Battery Performance: The Gemini Classic is great in the studio, but what if you need to work on location? Typical Flashes (Recycle Time) Also available for the Travelpak Universal Mains Charger. Replacement or spare mains charger for Travelpak batteries. Includes a set of international plug types for travelling overseas. BW1227 Universal Mains Charger.
gemini classic accessories 50º keylite reflector This is a very high output 24cm (91⁄2") reflector that creates a highly specular result. It’s the perfect reflector to be used where maximum light output is required. It’s also a superb reflector for bouncing light off ceilings or simply to give the maximum possible depth of field. BW1886 This 15" matt-finished reflector is supplied with a double diffuser cap that covers the flash tube and modelling lamp for added softness.
- Gemini Classic | Accessories gemini classic accessories 40º sunlite reflector 65º maxilite reflector 60º grid reflector A 43cm (17") white-painted reflector designed to replicate sunlight for photographing items such as architectural models. The white-painted interior of the Sunlite reflector helps to ensure that an even light is delivered. BW1868 This is a good general-purpose direct reflector with an even coverage and a high light output.
Model: GM250C GM500C Max Power: 250Ws 500Ws Power Range: 5 Stops 5 Stops Power Control: Rotary Dial Rotary Dial Modelling Control: Rotary Dial / Proportional Rotary Dial / Proportional Digital Display: No No Plug-in Radio Trigger Option: Yes Yes Multi-voltage: No No Auto Dump: Yes Yes IR Remote Control: No No Flash Tube BW2030 (Clear). BW2032 (UV) BW2030 (Clear). BW2032 (UV) Fan Cooled: No No Modelling Lamp: 250W Halostar (BW1024) 250W Halostar (BW1024) Guide No.
classic BWL0580 | Gemini Classic www.bowens.co.
