Instruction Manual

LEVER TYPE DIAL TEST

INDICATOR INSTRUCTIONS

For more information visit www.baty.co.uk

precision measuring instruments

Lever Type Dial Test Indicators

– BL-9 / BL-10

Please carefully review these instructions to ensure proper and accurate

use of your new Test Indicator.

This indicator is designed to provide a true reading when the

angle between the contact point and component is 12°.

Any configuration of an angle other than 12° needs the displayed

value to be corrected. For a position of 0°, the correct value is:

Maintenance

No special maintenance is required. The bearings of the indicator

must not be oiled.

Displayed value x 1.022" or 1.022mm

Contact Point with 12º Position

Lever Type Dial Test Indicators_422_baty 19/07/2010 10:55 Page 1

PAGE 1
Lever Type Dial Test Indicators_422_baty 19/07/2010 10:55 Page 1 LEVER TYPE DIAL TEST INDICATOR INSTRUCTIONS Lever Type Dial Test Indicators – BL-9 / BL-10 Please carefully review these instructions to ensure proper and accurate use of your new Test Indicator. Contact Point with 12º Position This indicator is designed to provide a true reading when the angle between the contact point and component is 12°. Any configuration of an angle other than 12° needs the displayed value to be corrected.