User guide

For more information visit www.moore-and-wright.com Partners in Precision
CALIPER INSTRUCTIONS
Large Digitronic Workshop Caliper 150 Series
Please carefully review these instructions to ensure proper and accurate use of your new Digitronic Caliper.
Function
ON/OFF: Power on/off switch
ABS/INC: Relative/absolute measurement
ZERO: Zero setting button
mm/in: metric/inch conversion
SET: presetting button
HOLD: data hold button
Instructions
• OperatingCondition:
Temperature: 5-40°C
Relative Humidity: ≤80%
• Preventanyliquidfromcontactingtheprotectivesticker
• Neverapplyvoltage(e.g.Engravingwithanelectrograph)onanypartofthisCaliperforfearofdamagingthecircuit
• Presetastartingpointofmeasurementcorrectly(pleaserefertoOperations).
Unless presetting, do not press the “SET” button purposely for fear of measurement error
Technical Specifications
• Resolution:   0.01mm/0.0005"
• Repeatability:   0.01mm/0.0005"
• Accuracy:   0-600mm:+/-0.07mm
• Maximummeasuringspeed: 3mpersecond
• Battery:   CR20323VLithiumBattery
Instructions of Data Output
• Presetzeroandmetric/inchsystem
• Connecttheendoftheinterfacecabletothecomputer.TheothertothedataoutputportofthisCaliper
• StartthisCaliperandsoftware
• Movetheslidertothepositionyouwantandpressthebuttononcontrolboxfordataoutput
• Batterylife:approx.1year
Battery Replacement
Oncedisplaybeginsflashingorevennodisplay,slidethecoveropenasthearrowshowsandreplacewithanewbattery(CR2032)
Note:
 • Thepositivepoleofthebatterymustfaceout
 • Pleasepresetthestartingpointoveragainafterbatteryreplacement
Electronics
Data
Output
Battery
Cover
Slider
External Measuring Faces
Internal Measuring Faces
Fine Adjustment
Slider
Scale
Locking
Screw
MW150-DDL_Manual_A4.indd 1 21/05/2013 08:07