ASW CM Owner’s Manual
ASW CM Owner’s manual Figure 1 English ...............................1 Français ..............................4 Deutsch ..............................9 Español ............................13 Português ..........................17 Italiano .............................21 Nederlands .......................25 Ελληνικά .........................29 Русский ...........................34 Figure 2 ................................39 .............................42 Norsk ...............................46 Svenska ..
Figure 4 RIGHT - LEFT + + - SPEAKERS OUT LINE IN LINE OUT L R L L + R R Power Amplifier Pre-Amplifier NO.1 NO.2 E60065-00 Figure 5 RIGHT - LINE OUT LEFT + - LINE IN + SPEAKERS OUT L R Pre-Amplifier L L R R + Power Amplifier NO.2 No.
unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarised plug. When using an extension power-supply cord or a powersupply cord other than that supplied with the appliance, it should be fitted with the appropriate moulded-on plugs and carry safety approval appropriate to the country of use.
Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. e If the product has been dropped, or damaged in any way. f When the product exhibits a distinct change in performance – this indicates a need for service.
Electrical connections Double-check the connections • The LOW-PASS FILTER switch (5) Disconnect all sound system equipment from the power supply until the signal connections have been made and checked. This avoids the risk of damage whilst connections are made or broken. Before auditioning the sound quality of your new installation and fine-tuning it, double-check the connections.
2-channel audio The optimum settings of the PHASE switch and the LOW-PASS FREQUENCY control are interrelated and also dependent on the low-frequency cut-off characteristic of the satellite speakers and the relative positions of all the speakers in the installation. Set the system up in the preferred position and play some programme with a steady bass content.
II08879 Issue 1 ASW CM Description Drive unit System frequency range System frequency response Amplifier Active closed-box subwoofer system One ø250mm (10 in) composite aluminium/paper/Kevlar® cone long-throw -6dB 17Hz – 40/140Hz adjustable (EQ at ‘A’) ±3dB 22Hz – 31/110Hz adjustable (EQ at ‘A’) Power output Input impedance Signal/Noise Functions Low-Pass Filter High-Pass Filter 500W continuous 33kΩ 90dB Input level Low-pass filter frequency Low-pass filter bypass Bass roll-off alignment Auto-sense on/s