Use and Care Manual

75
18. Count the number of threads showing on the Lift Motor Shaft between
the Collar Nut and the Lift Motor base, and record the number.
19. Using the 18mm socket and wrench and 18mm open end wrench,
loosenandremovethehexheadboltsthatattachtheInclineAdjuster
Assembly to the Lift Motor shaft. Set the bolts aside for reassembly.
20. Carefully remove the old Incline Adjuster Assembly and discard.
Note: Do not rotate the Lift Motor Collar Nut on the Shaft while the Incline
Adjuster Assembly is not installed.
NOTICE: Do not crimp any cables.
21. Re-assemble the machine in the reverse order of when the parts were
removed.
Note: Be sure the number of threads showing on the Lift Motor
shaft between the Collar Nut and the Lift Motor base is the
same as the number recorded in Step 16. If the number is
different, turn the collar nut until the thread count is the same.
22. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
Distance between
Collar Nut and Lift
Motor Base
Lift Motor Shaft
Lift Motor Collar
Nut