Use and Care Manual

108
1. Be sure the Incline Assembly on the Rail Assembly is fully lowered.
Do not adjust the incline angle when on the machine.
Be sure the area below the machine is clear before lowering.
PushtheInclineLevelDecrease()buttontochangetheinclineangleof
the rail assembly, or push the 0% Incline Level Quick Button.
Disconnect all power and allow to sit for 5 minutes.
2.Usinga6mmhexwrenchand13mmwrench,removetheindicated
hardware(byarrow)fromtheinsideofthePedal.
3.Usinga6mmhexwrench,removetheindicatedhardware(byoval)
from the Lower Handlebar Arm and Pedal.
Be aware that the Handlebar Arm will be loose and will pivot
when the hardware is removed. Safely allow the Handlebar
Arm to pivot downward and come to rest. Be sure not to be in
the path of the Handlebar Arm.
Note: To assist with reassembly, observe how the Pivot Sleeve engages
ushwiththeLowerHandlebarArm.
4.RemovethePedal.
5.UsingaStandardscrewdriver,removetheindicatedCap(byarrow)
from the Frame Assembly.
!
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from
the wall outlet and wait 5 minutes before cleaning, maintaining or repairing this machine. Place the power cord in
a secure location.
Pedal
Leg