Use and Care Manual

116
23. Pull back on the Brake Arm enough to clear the Motor Pulley Shaft.
Move it to the side and gently allow it to come to rest against the
cardboardontheywheel.
24.LoosenandremovethetwosocketheadboltsfromtheServoMotor
(indicatedbyovals).
25. Remove the Servo Motor and discard it.
26. Install the new Servo Motor and adjust it to the previously recorded
position.
NOTICE: Do not touch the Potentiometer. Do not crimp any cables.
27. Tie the end of the string at the hole in the Mast to the end of the
Console Cable on the new Servo Motor. Carefully pull the cable through
the hole to the top of the Console Mast mount. Untie the string and
discard it.
NOTICE: Do not crimp the cables.
28. Reinstall the Console Mast with the Upper Shroud. Turn the power on.
Machine is on. Current is active. There is risk of electrical
shock.
29. Use the console to set the resistance to the highest level. Unplug the
machine.
Disconnect all power and allow to sit for 5 minutes.
MCB
Cover
Input/Output (I/O) Cable
Lift Motor Cable
Motor Pulley
Shaft
Brake Arm
Speed Sensor Cable
Servo Motor Cable
Lower Input/Output
(I/O) Cable
Potentiometer