Use and Care Manual

14
Condition/Problem Things to Check Solution
Resistance does not change
(machineturnsonandoper-
ates)
Check Console Check for visual sign that Console is damaged. Replace Console if damaged.
Check data cable integrity All wires in cable should be intact. If any are visibly crimped or cut, replace
cable.
Check data cable connections/
orientation
Be sure cable is connected securely and oriented properly. Reseat all con-
nections. Small latch on connector should line up and snap into place.
Resistance handlebar
connection
Be sure cable from right Upper Handlebar and cables to Console are secure
and undamaged.
CheckServoMotor(requires
shroudremoval)
If magnets move, adjust until they are within the proper range. Replace
Servo Motor if not functioning properly.
MCB(requiresshroudremoval) Replace MCB.
If the above steps do not resolve the problem, contact Customer Care for
further assistance.
Inclinedoesnotadjust(machine
turnsonandoperates)
Check Console Check for visual sign that Console is damaged. Replace Console if damaged.
Incline handlebar connection Be sure cable from left Upper Handlebar and cables to Console are secure
and undamaged.
Lower and Upper I/O Cables
(requiresshroudremoval)
All wires in the cables should be intact. If any are cut or crimped, replace
cable.
Incline Adjuster Assembly
(requiresshroudremoval)
Be sure Incline Adjuster Assembly is attached to Incline Motor drive screw.
If the above steps do not resolve the problem, contact Customer Care for
further assistance.
Consoleshutsoff(enterssleep
mode)whileinuse
Checkelectrical(wall)outlet Make sure unit is plugged into a functioning wall outlet.
Check connection at front of unit Connection should be secure and undamaged. Replace adapter or connec-
tion at unit if either are damaged.
Check data cable integrity All wires in the cable should be intact. If any are cut or crimped, replace
cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly. Small latch on
connector should line up and snap into place.
Reset machine Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet.
Checkmagnetposition(requires
shroudremoval)
Magnet should be in place on pulley.
CheckSpeedSensor(requires
shroudremoval)
Speed sensor should be aligned with magnet and connected to data cable.
Realign sensor if necessary. Replace if there is any damage to the sensor or
the connecting wire.
Fan will not turn on or will not
turn off
Check data cable integrity All wires in cable should be intact. If any are cut or crimped, replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly. Small latch on
connector should line up and snap into place.
Reset machine Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet.
Fan will not turn on, but Console
operates
Check for blockage of fan Unplug unit from electrical outlet for 5 minutes. Remove material from fan. If
necessary, detach the Console to help with removal. Replace the Console if
unable to remove blockage.