Use and Care Manual

69
14.Removetheindicatedgrommet(byarrow)fromtheConsolemastthat
secures the Remote Incline Cable and remove it from the Cable.
15. Tie a length of string to the end of the Remote Incline Cable. Hold
the other end of the Remote Incline Cable and carefully pull it out of the
ConsoleMastsothatthestringextendsthroughtheConsoleMast.
NOTICE: Do not crimp the cables.
16. Untie the string from the old Remote Incline Cable and discard the old
cable.
17. Tie the end of the string out of the side of the Cable Mast to the upper
end of the replacement Remote Incline Cable. Hold the other end of the
string and carefully pull the new Remote Incline Cable through the Cable
Mast.
NOTICE: Do not crimp the cables.
18. Untie the string from the new Remote Incline Cable.
19. Re-assemble the machine in the reverse order of when the parts were
removed.
NOTICE: Do not crimp the cables.
20. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.