Use and Care Manual

13.Usinga6mmhexwrench,removethehardware(indicated)fromthe

Console Mast. Slightly pull the Mast up and disconnect the cables. Set the

hardware aside for reassembly.

NOTICE: Do not crimp the cables. Do not allow the cables to fall

down into the Main Unit or into the Console Mast. This

step may require two people.

14.Tiealengthofstringtothelowerendofthecablebeingreplaced.

Hold the other end of the cable and carefully pull it out of the Console

MastsothatthestringextendsthroughtheConsoleMast.

NOTICE: Do not crimp or pull other cables out of the Console Mast.

15. Untie the string from the old cable and discard it.

16. Tie the lower end of the string coming out of the bottom of the Cable

Mast to the upper end of the replacement cable. Hold the upper end of the

string and carefully pull the new cable through the Cable Mast.

NOTICE: Do not crimp or pull other cables out of the Console Mast.

17. Untie the string from the new cable.

18. Re-assemble the machine in the reverse order of when the parts were

removed.

NOTICE: Do not crimp the cables.

19. Final Inspection

Inspect your machine to ensure that all hardware is tight and components

are properly assembled.

Do not use until the machine has been fully assembled and

inspected for correct performance in accordance with the

Owner’s Manual.

Console Mast