Use and Care Manual

14.Usingasmallstandardscrewdriver,gentlyprytheCapoffofthe

center of the Right Crank Cover.

15.Usinga#2Phillipsscrewdriver,removethe6indicatedscrews(ovals

andarrows)fromtheRightCrankCover.

NOTICE: To assist with re-assembly, observe that the white arrows

are the longer screws.

16.ObservethecableroutingfromtheMotorControlBoard(MCB)

Assembly on your machine.

• PowerInletCable(PowerswitchtoMCB)

• LiftMotorCable,Lower(LiftMotortoMCB)

• LiftMotorWire,Upper(MCBtoConsole)

• ServoControlWire(MCBtoServoMotor)

• SpeedSensorCable(SpeedSensortoServoMotor)

• Input/Output(I/O)Cable(ServoMotortoConsole)

Note: Be sure to note where all cables are routed for re-assembly.

Crank Cover

Cap (removed from

center of Crank Cover)

MCB

Cover

Input/Output (I/O) Cable

Lift Motor Cable