Use and Care Manual

113
Cap
10.Usinga#2Phillipsscrewdriver,removetheindicatedscrew(byarrow)
from the Rear Shroud.
11. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it releases. Then move the screwdriver to the bottom and gently pry
until the Rear Shroud comes off.
12. Remove the Caps from the machine.
13.Usinga#2Phillipsscrewdriver,removetheindicated(byoval)screw
and only loosen the lowest indicated screw (arrow) from the Left Fan
Cover.
14.TheLeftFanCoverAssemblyhasatabthatneedstobepushed
upward to clear the loosened screw. While pushing up on the tab, remove
the Left Fan Cover Assembly.
15. Remove the Left Fan Cover Assembly from the machine. Be sure to
note how the fan screens are set into the Left Fan Cover to assist with the
replacement procedure.
16.Usinga#2Phillipsscrewdriver,removethe2indicatedscrewsfrom
the Right Crank Cover.
17. Remove the Right Crank Cover from the machine.
18. Place a rag or protective material below the Right Connector Arm to
protect the Shrouds from potential scratches from the Connector Arms.
19. Using a 6mm hex wrench, remove the hardware that connects the
Right Connector Arm and the Pivot Arm.
Note: The Connector Arm will pivot downward if not lowered slowly onto
the rag protecting the Shroud.
Crank Cover
Pivot Arm
Connector Arm
Rear Shroud
Cap
Cap