Use and Care Manual

25.Usinga#2Phillipsscrewdriver,removethescrewsfromtheLeft

Shroud. ( 9 screws on the Left Shroud) Remove the upper screws

labeled ‘ * ’ last.

26.Usinga4mmhexwrench,removethescrewindicatedby“A”fromthe

Drive Belt Tensioner Arm.

27. Using a 10mm wrench, remove the securing nuts (if present) from the

back side of the Drive Pulley.

28. Using a 8mm hex wrench, loosen the screw indicated by “B” until the

Drive Belt is free enough to be removed from the Drive Pulley. Remove

the Drive Belt.

Keep ngers out of any pinch opportunities when removing

the Fan Belt.

29. Using a 5mm hex wrench, remove the four screws that attach the

Drive Pulley. Be sure to support the weight of the Drive Pulley when

removing hardware because it will fall.

30. Using a 5mm hex wrench, attach the new Drive Pulley to the Frame

Assembly.

31. Replace the Drive Belt around the new Drive Pulley.

32. Replace and tighten the “A” screw on the Drive Belt Tensioner Arm,

and then tighten the “B” screw.

Right Side Left Side

Drive Belt

Tensioner Arm

Drive Belt

Drive Pulley