Use and Care Manual

10.Usinga#2Phillipsscrewdriver,removethe2indicatedscrews

(by ovals) from the Left Crank Cover.

Note: The image displays the Right Crank Cover being removed.

11. Remove the Left Crank Cover from the machine.

12. Place a rag or protective material below the Left Connector Arm

to protect the Shroud from potential scratches from the Connector

Arm.

13. Using a 6mm hex wrench, remove the indicated hardware (with

arrows) that connects the Left Connector Arm and the Pivot Arm.

Note: The Connector Arm will pivot downward if not lowered slowly

onto the rag protecting the Shroud.

14.Usinga9/16”or14mmsocketandwrench,removethenutfrom

the Left Crank Assembly.

15.AdjusttheCrankPulleruntiltheendoftheBoltisushwiththe

Nut (as shown).

16. Carefully thread the Crank Puller into the Left Crank Arm. Be sure

the Crank Puller has at least three rounds of threads inserted.

Left Crank Assembly

Crank Cover

Pivot Arm

Connector Arm