Use and Care Manual

10. Using a 5mm hex wrench, remove the screws (indicated by ovals)

from the Console Assembly.

11. Carefully lift the Console Assembly and expose the Cable Connec-

tions.

Note: Do not crimp any of the Console Cables. This step may require two

people.

12. Carefully disconnect the Cables while not allowing them to fall into the

Console Mast.

Note: Do not crimp any of the Console Cables.

13. Gently pull the old I/O Cable out of the frame, routing the new I/O

Cable into place.

14.Removethepieceofwireorstring,anddiscardtheoldI/OCable.

15. Secure the lower Cables with a replacement Upper Zip-Tie.

16. Re-assemble the machine in the reverse order of when the parts were removed.

Note: When attaching the Console Assembly, do not fully tighten the hardware until all hardware has been hand tightened. Do not crimp any of the

Console Cables.

17. Final Inspection

Inspect your machine to ensure that all hardware is tight and components are properly assembled.

Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner’s

Manual.