® Bowflex® BodyTower™ Assembly Manual Manual en Español Latino Americano: http://www.bowflex.
Table of Contents Important Safety Instructions..............................................................3 Specifications.........................................................................................4 Parts ........................................................................................................5 Hardware................................................................................................6 Tools.........................................................................
Important Safety Instructions This icon means a potentially hazardous situation which, if not avoided, could result in death or serious injury. Before using this equipment, obey the following warnings: Read and understand all warnings on this equipment. Carefully read and understand the Assembly Manual. • Keep bystanders and children away from the product you are assembling at all times. • Do not assemble this equipment outdoors or in a wet or moist location.
Specifications 76.9” 195.4 cm 49.7” 126.3 cm 51.2” 130.1 cm Before Assembly Select the area where you are going to set up and operate your equipment. For safe operation, the location must be on a hard, level surface. Allow a workout area of minimum 123” x 123” (3.1m x 3.1m). Follow these basic points when you assemble your equipment: 1. Read and understand the “Important Safety Instructions” before assembly. 2. Collect all the pieces necessary for each assembly step. 3.
Parts 9 4 5 12 6 7 10 8 11 3 2 1 Ref. Qty Description Ref.
Hardware Guide A B C D E G H I J K F Ref. Qty Description Ref.
Assembly Steps Step 1: Attach Base Cross Brace to Base Frames Note: D o not tighten the hardware until the parts of the base are together. Make sure that the square on the bolt is in the square hole (1a) on the Base Cross Brace. Do not install the hardware that joins the left and right Base Frames at this time.
Assembly Steps Step 2: Attach Uprights to Cross Brace Note: D o not completely tighten the hardware at this time.
Assembly Steps Step 3: Attach E-Z Adjust Arms to Back Pad Assembly 6 7 8 9
Assembly Steps Step 4: Install the E-Z Adjust Bar Assembly on the Uprights Remove the Locking Pins (7a) from E-Z Adjust brackets before you install the assembly on the Uprights. Tilt the assembly to put it on the Uprights. If necessary, remove end caps from the Uprights. Grasp the assembly near the Uprights and tilt it to move clear of the height adjustment holes in the Uprights. Carefully slide it down the Uprights.
Assembly Steps Step 5: Install the Pull Up Bar to the Uprights Note: M ove the E-Z Adjust Bar to the bottom of the Uprights and tighten the hardware at the base of the Uprights completely. Then move the E-Z Adjust Bar to the top of the Uprights and tighten the hardware on the Pull Up Bar. Make sure that the E-Z Adjust Bar is locked in position with the locking pins after each move.
Assembly Steps Step 6: Install the Backbone to the Pull Up Bar and Base Note: Attach the Backbone to the Pull Up Bar first. For the carriage bolts at the base, you can put a piece of tape on each bolt head to hold it in position during installation. Tighten the outer bolts first. Tighten all hardware. Slide the E-Z Adjust Bar up and down to be sure it moves easily on the Uprights.
Assembly Steps Step 7: Install Placard on Backbone 10 13
Assembly Steps Step 8: Attach Handgrips and Sling Straps 12 11 14
Assembly Steps Step 9: Final Inspection Inspect your equipment to ensure that all fasteners are tight, the equipment is level, and components are properly assembled. Do not use the equipment until the equipment has been fully assembled and inspected for correct performance in accordance with the Owner’s Manual. Note: R ecord serial number in the Serial Number field at the beginning of the Owner’s Manual.
Nautilus® Bowflex® Schwinn® Fitness 004-4693-111811C Universal®
