Owner's Manual

Assembly Guide

Figure 12

Figure 11

Step 11 - Attach the Rollers to the Leg Extension

Locate the following items:

• From Step 10 - Main Assembly

• Item #14 - Foam Rollers

• Item #15 - Foam Roller End Caps

• Item #16 - Short Chrome Roller Tubes

• Item #17 - Long Chrome Roller Tube

• Item #18 - Roller Tube Spacers

There are (3) Chrome Roller Tubes on the Leg Extension.

Place the Long Chrome Roller Tube (Item #17) through the

hole closest to the Seat.

There are two holes possible in the Leg Extension Pivot

Tube for the lower of the Short Chrome Roller Tubes (Item

#16). Select the correct lower hole for your height - the

Roller should rest on your lower shin above the ankle. Insert

the (3) Chrome Roller Tubes through the holes on the Leg

Extension Pivot Tube and Rear Leg, as shown in Figure 11

Slide (2) Roller Tube Spacers (Item #18) over each end of

the Long Chrome Roller Tube. Then, slide (2) Foam Rollers

(Item #14) over the ends of all three tubes. Cap the Roller

Tubes with the (6) Foam Roller End Caps (Item #15).

Note: Use a Rubber Mallet to secure the End Caps.

Step 12 - Attach Leg Cable to the Leg Extension

Locate the following items:

• From Step 11 - Main Assembly

• Item #AA - (1) Leg Cable

• Item #F - (1) 3/8" X 2 1/2" Button Head Screw

• Item #N - (2) 3/8" Washers

• Item #O - (1) 3/8" Nylock Nut

• Item #Q - (1) Bolt Cover

Slide the hooked end of the Leg Cable beneath the Leg

Extension Pulley and into the hole on the Leg Extension Pivot

Tube, as shown in Figure 12.

Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8"

X 2 1/2" Button Head Screw (Item #F). Thread the screw

through holes in the Leg Extension and cable end. Place (1)

3/8" Washer and (1) 3/8" Nylock Nut (Item #O) over the

end of the screw, as shown in Figure 12, and tighten.

Completely tighten hardware installed during Step 12.

Place (1) Bolt Cover (Item #Q) over the Nylock Nut

installed during Step 12.