Owner's Manual

55
Abdominal Exercises
Reverse Crunch — Spinal Flexion
Resisted Reverse Crunch — Spinal Flexion
START ACTION
START
Face the Power Rods®, and
attach an Ankle Cuff to each
ankle.
Lie back on the bench, head
away from the Power Rods®.
Bend your hips and knees at 90°
angles, as shown.
Reach behind your head and
grasp the Seat.
Relax your neck.
Tighten your abs and slowly curl
your hips toward your rib cage.
Move as far as you can without
using your legs or curling onto
your shoulder blades.
Slowly reverse the motion,
returning to the Start position
without relaxing your abs.
FINISH
START ACTION
START
Lie on the bench, head toward
the Power Rods®, grasp bench
for support.
Bend your hips and knees
until your legs are in a seated”
position as shown above—knees
and hips at 90° angles.
If maintaining this position is
difficult, adjust to one you can
maintain for the duration of this
exercise. As you strengthen, this
position will become easier.
Tighten your abs, and then
slowly curly your hips toward
your rib cage. Move as far as you
can without using your legs to
get momentum.
Do not curl up onto your
shoulder blades.
Slowly reverse the motion,
returning to the Start position
without relaxing.
FINISH
Muscles worked:
Rectus Abdominus
Bench Position:
Flat Bench Back
Accessory:
None
Pulleys:
None
Success Tips
Keep your upper body, knees and hips
stationary. Relax your neck.
Tighten your abs before you move.
Allow exhalation up and inhalation
down without exaggerating breathing.
Contract as far into the movement as
possible. Lower under control. Keep abs
tight during entire motion.
Muscles worked:
Rectus Abdominus; Obliques
Bench Position:
Flat Bench Forward
Accessory:
Ankle Cuffs
Pulleys:
Chest Bar
Success Tips
Allow exhalation up and inhalation
down without exaggerating breathing.
Do not ‘kick into the motion, but allow
body to slowly initiate movement.
Tighten your abs throughout the entire
exercise, relaxing only at the end of each
set. Keep hips and knees motionless.
Move slowly to eliminate momentum.