Owner's Manual

61
Leg Exercises
Standing Hip Abduction
Seated Hip Adduction
START ACTION
START
Sit sideways on the bench and
attach an Ankle Cuff to the ankle
closest to the Power Rods®.
Sit far enough from the Power
Rods® that there is tension in the
cable at the start of the exercise.
Lift leg with cuff in front of you,
at a 45° angle from your trunk
(toward Power Rods®)—do not
lock your knee.
You may hold onto the bench for
added stability.
Slowly allow the attached leg to
move inward, toward the center
as you face forward, keeping your
hips and spine perfectly still.
Keeping the leg still, slowly move
it back into the Start position.
FINISH
START ACTION
START
• Stand to one side of the Seat Rail,
one side next to Power Rods®.
• Secure Ankle Cuff around the
ankle furthest from the Power
Rods®. Keep leg straightened, but
knee loose.
• Adjust your position so that there
is some tension in the cables at the
start of this exercise.
• You may use your hand on the
Lower Lat Tower or Chest Bar to
stabilize movement.
• Slowly move the attached leg
outward, away from the Power
Rods®, at a 30-45° angle,
keeping your hips and spine
motionless.
• Slowly return to the Start
position without relaxing tension
in your leg.
• Keep your hips level during
movement.
FINISH
Muscles worked:
Gluteus Maximus
Bench Position:
Removed
Accessory:
Ankle Cuff
Pulleys:
Chest Bar
Success Tips
Keep your chest lifted, spine aligned,
abs tight and a slight arch in your lower
back.
Do not bend from waist or lower back.
Keep your abs tight throughout
movement.
Keep working leg straight or only very
slightly bent.
Use only a small range of motion.
Muscles worked:
Adductor Longus; Gluteus Medius
Bench Position:
Flat Bench Back
Accessory:
Ankle Cuff
Pulleys:
Chest Bar
Success Tips
Do not cross the attached leg in front
of the stabilized leg.
Keep abs tight and do not lift your
hips or excessively arch your back.
Keep your spine straight and your
hips level—do not raise your hips
during motion.
Use only a small range of motion.